Hi, I recently began using Protoshare. I have a couple questions about the tools.
1. When aligning a group of items to another item, e.g., its left edge, I notice all items in the group are aligned to the parent. Is there a way to prevent this behavior so that only the group boundary is aligned, not the items within it?
2. When putting a master component in a wireframe, I notice there is a bounding box that is not the same size as the master component, e.g., I create a master component "box" that is 500 x 500. In the master view the width and height is 500 x 500 (same as the dimensions). When I put the master component "box" in a wireframe, it has a width and height of 200 x 100, even though it is actually 500 x 500. Is there a setting so the width and height are the same as the master component's?
This is problematic as alignment is based not on the actual dimensions, but the reduced ones. The only fix I have found is to manually set the width and height to what they should be, i.e., 500 x 500. I tried to delete the width and height in the Inspector hoping it would auto-expand, and tried "auto" as well, but neither worked.