Re: bug with turns?

Is something not working the way you expect? Enter it here because someone else might have a similar issue.
ayan
Posts: 1
Joined: Tue Apr 21, 2015 12:12 am

Re: bug with turns?

Postby ayan » Tue Apr 21, 2015 12:14 am

Hi

Not sure how to describe this, but here it goes.

First Enter Test mode.
I have an container (C1) that on hover triggers a state, which shows another container (C2), and when you move the mouse off C1 the opposite state is triggered automatically and C2 disappears. This all works fine most of time time, but quite often the off state doesn't get triggered which leaves you with C2 visible, and from then on the only way to fix it is to exit test mode, go to C2 and toggle the visibility. When this happens no states seems to get triggered when hovering on/off C1 at all.
watson

Nick Jennings
Posts: 165
Joined: Mon May 14, 2012 12:06 pm

Re: bug with turns?

Postby Nick Jennings » Tue Apr 21, 2015 1:46 pm

Hi Ayan,

The only way that the state value would remain active is if the mouse cursor travels over to another component with the same actions set (On Hover with the same state value set), but it sounds like that may not be the case here. This could be a possible bug. Do you know if this happens on a specific design or project?

There are a few troubleshooting steps that you can try out:

Clearing your browser's cache. Stale cache can sometimes interfer with actions/navigation, and clearing can resolve the issue.
Testing this on another browser. It may be a problem to a specific browser/version.

If you still run into the problem, send us an e-mail via our Contact Us forum with your Domain, Project, and Page/Design that you are having the problem on.


Return to “Troubleshooting & Bug Reports”

Who is online

Users browsing this forum: No registered users and 2 guests

cron